If you’re getting frustrated with your machine, take a deep breath, and go through the following list. (You can click on the images to make them bigger.)
1. When you see this on the back of your fabric, it usually means that the top thread hasn’t been threaded properly, and is probably not completely in the tension disks. Remember to lift the presser foot when you thread your machine. This will open the tension disks, so the thread can go inside them. Re-thread the top and bobbin threads. Be sure you are threading correctly.
2. Adjust your tensions. Set your upper tension at the “normal” setting. It is usually marked on the dial. If not, set it at 3. Thread the machine with a dark thread on top, and a light thread in the bobbin. Then sew with a medium zig-zag stitch.
3. Do you need to adjust your bobbin case tension? Remember, “righty-tighty, lefty-loosey.”
Here are some pictures of bobbin cases. Your drop-in bobbin also has a bobbin case, that you can adjust the tension on. They are the plastic ones on the right.
The top thread should be just a “tick” on the back of the fabric. (See the "Sewing Machines Tensions" page for more details.)
7. Are the feed dogs up? Do you know where your feed dog switch is? Flip the switch, and rotate the hand wheel one complete turn to bring them up. Please don’t try to force them up. On many machines, it just takes one rotation of the hand wheel to bring them back up.
8. Is your bobbin winder switched on? If your machine is locked-up, and you can’t even turn the hand wheel, it may be that your bobbin winder is on. Or if you press the foot control, and the machine makes a noise, but doesn’t sew, it may also be that your bobbin winder is on. Switch it off or tighten the clutch on the hand wheel (on an older machine).
9. If your fabric isn't feeding through the machine, check your presser foot tension, if your machine has one. This controls how tightly the fabric is squeezed between the presser foot and feed dogs. It is usually on the top, left of your machine. You can tell if it’s too loose by lifting and lowering the presser foot lever. You should feel some resistance. Tighten it if it’s too loose.
10. Is the bobbin in the bobbin case correctly? Put the bobbin in so the thread makes a “lazy S” as the thread is pulled into the slit. In other words, you don’t want the thread rolling off the bobbin and straight into the slit. You want the thread to turn back, then go into the slit. Usually, with oscillating or rotary hook systems, when you put your bobbin in the bobbin case and pull the thread, it should rotate clock-wise. Drop-in bobbins will usually rotate counter-clock-wise. Are you using the correct bobbin for your machine? Check the height and width. It should fit snuggly in the bobbin case, but not bind. And it shouldn't be taller than the bobbin case (unless your machine is a Singer Featherweight). Make sure your bobbin isn’t wound loose or sloppy, and that there are no threads dangling out of the center or wrapped around the outside.
11. Check your stitch length. If your machine is “eating” your fabric, you may want to make the stitch length a little longer. Or if you’re starting on a pointed corner, sew on a scrap before feeding the corner under the needle.
12. If you’ve gone through the list, and you’re still not sewing well, you’ll probably need to take your machine to the shop. Your machine may just need a deep cleaning. Or, it’s possible that the timing is off. You’ll know this if the needle thread isn’t picking up the bobbin thread, or if the machine is skipping stitches. What causes the timing to go out is hitting a big pin, or sewing over a really thick seam or breaking a needle. Adjusting the timing is something only a trained professional should do.